The short version of counterion fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-09-28 and is reviewed periodically as new material appears.
BPC-157 is normally distributed as a lyophilised powder that ranges from white to off-white in appearance. The peptide dissolves readily in water, normal saline, and common aqueous buffers, and it is poorly soluble in nonpolar solvents such as hexane or vegetable oils. Lyophilised vials take up moisture if left open, which changes the mass of powder in the container and complicates any later weighing. Because the material is handled in small quantities, static and adhesion to glass or plastic can also cause noticeable losses during transfer.
The main chemical liabilities of this sequence are peptide-bond hydrolysis and possible aspartate-related reactions, since the peptide contains aspartic acid residues but no cysteine, methionine, or tryptophan. Absence of those three residues removes the most common oxidation and disulfide pathways from consideration. Studies of related peptides indicate that aspartate isomerisation and aspartimide formation occur most readily at Asp-Gly and Asp-Ala positions, and open questions remain about how quickly those reactions proceed under ordinary laboratory conditions. Storage guidance typically emphasises cool, dry, dark conditions to slow hydrolysis.
A freeze-dried sample is generally the most stable form and is commonly held at minus twenty degrees Celsius or lower for long-term keeping, with brief transfers at room temperature. The solid is hygroscopic, so vials are warmed to ambient temperature before opening to prevent condensation from degrading the contents. Light exposure and repeated temperature cycling are both avoided in routine handling. Storage over a desiccant is a common laboratory practice that limits moisture uptake during repeated access.
Once dissolved, the material is considerably less stable than the dry solid. Aqueous solutions are usually kept cold and used within a short window, and neutral or mildly acidic buffers are preferred over strongly alkaline conditions. Freeze-thaw cycles promote aggregation and loss of material to container surfaces, so dividing a batch into single-use aliquots is standard. Adsorption to plastic and glass can lower the measured concentration, meaning solution strength may need rechecking before an experiment.
Identity and purity are established with complementary methods rather than one test. Reverse-phase high-performance liquid chromatography separates the main peak from deletion sequences and oxidized variants, and its area percentage is the usual purity figure. Mass spectrometry confirms the expected molecular mass and can flag truncations or modifications that chromatography alone might miss. Amino acid analysis and peptide mapping add sequence-level confirmation, while residual counter-ion and water content are measured separately.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised material; shade varies slightly between lots |
| Solubility in water | Freely soluble | Dissolves in water, saline, and aqueous buffers |
| Solubility in nonpolar solvents | Poorly soluble | Not compatible with oils or hydrocarbon solvents |
| Typical storage temperature | About −20 °C | Lyophilised, dry, dark storage slows hydrolysis |
| Common purity method | Reversed-phase HPLC | Area percentage, usually paired with mass spectrometry |
Supplied material is typically a lyophilized white to off-white powder. The peptide is freely soluble in water and in common aqueous buffers, which allows it to be handled as a stock solution. Because the sequence contains no cysteine, disulfide cross-linking is not a route of degradation. The absence of aromatic residues means ultraviolet absorbance at 280 nm is minimal, so quantification usually relies on peptide bond absorbance near 214 nm or on amino acid analysis.
Common synonyms in catalogs include pentadecapeptide BPC 157, BPC157, and the full sequence name. A CAS registry number in the 137525-51-0 range is frequently listed, though the assignment should be verified against the supplier certificate of analysis. The name itself is not a pharmacopoeial designation, and there is no standardized international nonproprietary name. Distinguishing genuine material from related fragments generally requires mass spectrometry, since several truncated sequences share similar chromatographic behavior.
BPC-157 is a synthetic peptide composed of fifteen amino acid residues, with the sequence Gly-Glu-Pro-Pro-Pro-Gly-Lys-Pro-Ala-Asp-Asp-Ala-Gly-Leu-Val. Its name derives from body protection compound, a term used for a protein fraction identified in human gastric juice. Researchers in Zagreb first reported the pentadecapeptide in the early 1990s and described it as a stable fragment of that larger protein. The compound is also catalogued as PL 14736 and, in some commercial contexts, as bepecin. Its molecular formula is C62H98N16O22 and its monoisotopic mass is approximately 1419 daltons.
Most published work on BPC-157 consists of preclinical studies, including rodent models of tissue injury, gastrointestinal lesions, and vascular or tendon damage, together with in vitro cell assays. Reviews frequently note that the mechanisms proposed in these papers remain incompletely characterised and that findings have not been confirmed in large randomised human trials. The compound is widely sold as a research chemical rather than a licensed medicine, and labels commonly carry a statement that it is not for human use. Whether any of the reported animal effects translate to humans is an open question rather than an established result.
Terminology in the literature is not fully standardised. Papers and product listings use BPC-157, BPC 157, and the longer phrase stable gastric pentadecapeptide BPC 157 interchangeably, and synonyms such as bepecin or PL 14736 appear in older or company-linked publications. Purity claims and reported masses can also differ between sources because peptide preparations may include counterions, residual solvents, or bound water. This variability complicates direct comparison of results across studies and makes the exact identity and grade of a given sample worth verifying. Discussions of the compound should therefore specify the source, salt form, and stated purity where those are known.
Identity and purity are established using reversed-phase high-performance liquid chromatography, which separates the peptide from related impurities and yields a percentage purity. Mass spectrometry, typically with electrospray ionization, confirms the molecular mass against the expected value. Amino acid analysis or peptide mapping provides additional sequence confirmation. These methods are complementary, since chromatography measures how much material is present while mass spectrometry verifies what that material is. A certificate of analysis normally reports both.
Analytical results depend on the column, gradient, and detector wavelength chosen by the laboratory, so purity values from different sources are not always directly comparable. Water content, counterion form, and residual trifluoroacetate affect both mass and purity calculations. Microbiological and endotoxin testing are separate from chemical purity and are not covered by a standard chromatographic run. Buyers evaluating a material typically request the full method description rather than a single purity figure.
Lyophilized peptide powder is generally stored at minus twenty degrees Celsius or lower and kept away from light and moisture. Under these conditions degradation is slow, and sealed vials remain stable for extended periods. Once dissolved, the material is less stable, particularly in aqueous buffers near neutral pH, where hydrolysis and oxidation proceed faster. Solutions are usually kept cold and used within days to weeks. Repeated freeze-thaw cycles are avoided because they encourage aggregation.
Most published studies examine BPC-157 in animal models rather than in humans. Common subjects include rats and mice, and researchers often use models of tissue injury, surgery, or induced inflammation. Reported endpoints include healing rates, blood vessel formation, and markers of tissue repair. These designs provide controlled comparisons, but findings in animals do not automatically transfer to people. Human clinical data remain limited and are frequently described as preliminary.
Doses in the literature are usually expressed in micrograms or nanograms per kilogram of body weight. Investigators have administered the peptide by several routes, including injection and oral delivery, depending on the question asked. Route and dose vary widely across studies, which complicates direct comparison of results. Many papers report effects at low doses, but the absence of a standardized protocol limits generalization. Reporting practice differs between research groups.
Some properties, such as the peptide's sequence and molecular mass, are firmly established. Other claims, particularly about mechanism and clinical benefit, remain open questions. Proposed mechanisms include effects on nitric oxide signaling and on cell migration, but these are hypotheses supported by limited evidence. Reviewers often note that the field lacks large controlled human trials. Positive animal findings are best treated as signals for further study rather than as settled conclusions.
The molecular weight of c7orf26 is 50 kilodaltons. The isoelectric point is 7.61. The protein sequence is uniquely rich for leucine at 15.8% of its composition, this may indicate a leucine-zipper. Further analysis from PSORT indicates that a leucine-zipper region is found at amino acid 318 and lasts until position 340 (22 amino acids long). There are no extremes with regards to acidity and alkalinity. c7orf26 has a positive charge cluster from amino acid 245 – 275 and does not have any negative, or mixed charge clusters. An even distribution of amino acids compose c7orf26. The percent composition of each amino acid is fairly consistent throughout the orthologs of the protein. The most distant ortholog displays the most variance in amino acid composition. There is a higher percent composition of tyrosine, histidine and leucine and a lower composition of valine and alanine.
Prof. Ralser serves since 2019 as head of the Institute of Biochemistry at the Charité – Universitätsmedizin Berlin, Germany; as well as since 2022 as group leader at the University of Oxford, UK. He studied genetics and molecular biology in Salzburg, Austria. He completed his PhD in 2006 at the Max Planck Institute for Molecular Genetics in Berlin, Germany, studying neurodegenerative diseases. This was followed by a postdoctoral fellowship at the Vrije Universiteit Amsterdam, Netherlands, where he started to explore mass spectrometry. He returned to the MPI for Molecular Genetics in 2007 to become junior group leader, but in 2011 relocated his group to the University of Cambridge, UK. He relocated again, becoming group leader at the newly opened Francis Crick Institute in London in 2013 (senior group leader since 2019). His group moved to Oxford in 2022.
The main method of treatment for potential death from signaling-related diseases involves either increasing or decreasing the susceptibility of apoptosis in diseased cells, depending on whether the disease is caused by either the inhibition of or excess apoptosis. For instance, treatments aim to restore apoptosis to treat diseases with deficient cell death and to increase the apoptotic threshold to treat diseases involved with excessive cell death. To stimulate apoptosis, one can increase the number of death receptor ligands (such as TNF or TRAIL), antagonize the anti-apoptotic Bcl-2 pathway, or introduce Smac mimetics to inhibit the inhibitor (IAPs). The addition of agents such as Herceptin, Iressa, or Gleevec works to stop cells from cycling and causes apoptosis activation by blocking growth and survival signaling further upstream. Finally, adding p53-MDM2 complexes displaces p53 and activates the p53 pathway, leading to cell cycle arrest and apoptosis. Many different methods can be used either to stimulate or to inhibit apoptosis in various places along the death signaling pathway. Apoptosis is a multi-step, multi-pathway cell-death programme that is inherent in every cell of the body. In cancer, the apoptosis cell-division ratio is altered. Cancer treatment by chemotherapy and irradiation kills target cells primarily by inducing apoptosis.
Sources: en.wikipedia.org
Some proteins that are disordered or helical as monomers, such as amyloid β (see amyloid plaque) can form β-sheet-rich oligomeric structures associated with pathological states. The amyloid β protein's oligomeric form is implicated as a cause of Alzheimer's. Its structure has yet to be determined in full, but recent data suggest that it may resemble an unusual two-strand β-helix. The side chains from the amino acid residues found in a β-sheet structure may also be arranged such that many of the adjacent sidechains on one side of the sheet are hydrophobic, while many of those adjacent to each other on the alternate side of the sheet are polar or charged (hydrophilic), which can be useful if the sheet is to form a boundary between polar/watery and nonpolar/greasy environments. Collagen helix Foldamers Folding (chemistry) Tertiary structure α-helix Structural motif Anatomy & Taxonomy of Protein Structures -survey Archived 2019-03-16 at the Wayback Machine NetSurfP - Secondary Structure and Surface Accessibility predictor
Casokinins and lactokinins, breakdown products of casein and whey, occur naturally after ingestion of milk products, especially cultured milk. Their role in blood pressure control is uncertain. The lactotripeptides Val-Pro-Pro and Ile-Pro-Pro produced by the probiotic Lactobacillus helveticus or derived from casein have been shown to have ACE-inhibiting and antihypertensive functions. In one study, L. helveticus PR4 was isolated from Italian cheeses.
Some cecropins (e.g. cecropin A, and cecropin B) have anticancer properties and are called anticancer peptides (ACPs). Hybrid ACPs based on Cecropin A have been studied for anticancer properties. The fruit fly Defensin prevents tumour growth, suspected to bind to tumour cells owing to cell membrane modifications common to most cancer cells, such as phosphatidylserine exposure. Cecropin A can destroy planktonic and sessile biofilm-forming uropathogenic E. coli (UPEC) cells, either alone or when combined with the antibiotic nalidixic acid, synergistically clearing infection in vivo (in the insect host Galleria mellonella) without off-target cytotoxicity. The multi-target mechanism of action involves outer membrane permeabilization followed by biofilm disruption triggered by the inhibition of efflux pump activity and interactions with extracellular and intracellular nucleic acids. Recently there has been some research to identify potential antimicrobial peptides from prokaryotes, aquatic organisms such as fish, and shellfish, and monotremes such as echidnas.
The Rho GTPase activating protein 31 is encoded in humans by the ARHGAP31 gene. It is a Cdc42/Rac1 GTPase regulator. ARHGAP31 encodes a GTPase-activating protein (GAP). A variety of cellular processes are regulated by Rho GTPases which cycle between an inactive form bound to GDP and an active form bound to GTP. This cycling between inactive and active forms is regulated by guanine nucleotide exchange factors and GAPs. The encoded protein is a GAP shown to regulate two GTPases involved in protein trafficking and cell growth. ARHGAP31 mutations result in a loss of available active Cdc42 and consequently disrupt actin cytoskeletal structures, causing syndromic cutis aplasia and limb anomalies. Human ARHGAP31 genome location and ARHGAP31 gene details page in the UCSC Genome Browser. This article incorporates text from the United States National Library of Medicine, which is in the public domain.
Sources: en.wikipedia.org
Lyophilised peptide powders are generally kept frozen or refrigerated, dry, and protected from light. Sealed vials limit moisture uptake and slow hydrolysis. Such guidance comes from general peptide chemistry rather than from stability studies specific to every product.
Reversed-phase HPLC is the standard approach, with purity expressed as a percentage of total peak area. Mass spectrometry confirms the expected molecular mass and can reveal adducts or truncated sequences. Neither method on its own establishes biological activity.
Small mass differences often reflect different counterions, such as acetate versus trifluoroacetate, or bound water rather than a different amino acid sequence. Mass spectrometry can distinguish these forms when the ionisation conditions are known. Exact sequence confirmation requires peptide mapping or tandem mass spectrometry.
Low temperature slows the chemical reactions, such as oxidation and hydrolysis, that break down a peptide chain. Water and oxygen are the main drivers of degradation, so a cold and dry environment extends usable life. Actual shelf life depends on the batch, the salt form, and the container.